FS627T VLAN Trunking Help

Hello

I am trying to setup 802.1q VLANs and need some advice. The details are below:

Devices:

GS726T Smart Switch (VLAN Switch)
Cisco RV042 Router (NOT VLAN Aware)
Airtight Networks Secure Wifi AP (VLAN Aware)

There will be two VLANs

Port 1-12 will be VLAN100
Port 12-24 will be VLAN200

AP is plugged into port 25 which needs to be a Netgear equivalent of a Cisco Trunk port.

Router has the following configuration and is plugged into port 26 on the switch. Router is not VLAN aware.

192.168.2.1/24 (DHCP Enabled)
192.168.1.1/24 (Static IPs only)

Here is how I have set it up:

Port 1-26 - U VLAN1 (Default)
Port 1-12 - U VLAN100
Port 13-24 - U VLAN200
Port 25 - U VLAN1, T VLAN100, T VLAN200

VLAN100 and VLAN200 can connect to the Internet but cannot talk to each other. So this works.

On the AP, I have two SSIDs for each of the Network. But neither of them are working. I cannot ping either of the gateways from the AP side. What am I doing wrong? How do I set a trunk port on a Netgear switch. The trunking option on the switch web interface does not seem to be the correct option. Thank you for the help