I have two WN604 access points that are bridged. I am running Firmware 3.0.2 on both access points. One is stuck in region US and the other in region UK.
Because the network was going slow, I tried to change the primary wireless channel. The access points were running 8 + 12 (region UK) and 8 + 4 (region US). I tried initially to change them so that the primary channel was 11 so they ran for a short while as 11 + 7 but then switched back to 8 + 12.
Because 11 is the maximum channel on region US, I decided to try channel 6 which ran as 6 + 10 for about an hour and then switched back to 8 + 12 or 8 + 4.
I don't understand why the channel is automatically switching back to the old setting. Can anyone provide some advice?
Because the network was going slow, I tried to change the primary wireless channel. The access points were running 8 + 12 (region UK) and 8 + 4 (region US). I tried initially to change them so that the primary channel was 11 so they ran for a short while as 11 + 7 but then switched back to 8 + 12.
Because 11 is the maximum channel on region US, I decided to try channel 6 which ran as 6 + 10 for about an hour and then switched back to 8 + 12 or 8 + 4.
I don't understand why the channel is automatically switching back to the old setting. Can anyone provide some advice?